DHCP mode: Vodafone router Modified on: Fri, 22 Dec, 2017 at 8:16 AM We will show you how to turn off the DHCP Server so CUJO can work in DHCP mode. You will need to make the changes as set out below to the DHCP Settings if you wish to connect your Router to CUJO in 'DHCP mode'.
Connect CUJO: At this point your CUJO has to be connected using just bottom CUJO port: Activate DHCP mode using CUJO app: Before turning off DHCP Server on Your Router you have to activate DHCP Server on CUJO (DHCP server will not be started yet until you reboot CUJO). If you see the manual setup instructions page on the CUJO app, this means the DHCP server was activated on CUJO. Turn OFF DHCP on your Router: Once you have connected CUJO and activated DHCP mode on it, you can turn off the DHCP Server on your Router by following the steps below; 1) Login to your Netgear router using the link and credentials below; Link: Password: vodafone 2) To be able to view the DHCP settings on your router you will need to switch to the 'Expert mode' as shown in the image below. Once you are in 'Expert Mode' proceed to 'Settings'-IPv4 and under the 'Home network' disable 'DHCP server' to apply the settings press the 'Apply' button 3) Reboot CUJO (unplug power from CUJO and plug it back) and router Once both devices reboot CUJO will start protecting all your network devices connected to the Vodafone router. Did you find it helpful?
If that Username and Password do not work you should RESET the modem to factory settings (see the instructions at the bottom of the page). Click the Log In button. The modem’s Dashboard screen displays. Configure the modem for Bigpipe:. From the menu on the left, select Advanced Setup.
Vodafone APN Settings By Mike Atherton, Dan Plummer 30 Aug 2018 If you're having any trouble connecting to 4G or 3G internet, or sending picture or multimedia messages on the Vodafone network, this guide to APN settings will help you get your phone setup and properly connected. Jun 11, 2015 - Vodafone is looking to change that though with its new Connect router, launched yesterday alongside its new broadband service.
The Wan interface selection screen appears. Select ADSL Uplink and click Next.
The Wide Area Network (WAN) Setup screen appears. Find the line with 0/100 and click Edit.
The ATM PVC Configuration screen appears Check VPI is 0 and VCI is 100. The Connection Type screen appears. Select PPP over ATM (PPPoA) and click Next. The PPP Username and Password screen appears. Put anything you like in PPP Username and PPP Password (don’t leave them blank) and click Next.
The Enable WAN Service screen appears. Select Enable WAN Service and click Next.
The WAN Setup – Summary screen appears. Click Save. You return to the Wide Area Network (WAN) Setup screen.
Click Save/Reboot Wait for modem to reboot. Enjoy the Bigpipe broadband piping into your place 🙂 Resetting the Modem.